PROCEED AMP 5 Spécifications télécharger pdf (Page 13)

Note also that if the amplifier has been disconnected from the AC mains

power by depressing the front panel power button, it cannot respond to a

remote turn-on command from a control unit.

3 INDICATOR LIGHTS

The power indicator light (above the small power button, below the large

standby button) is normally either on or off, indicating whether AC power

is being supplied to the amplifier. It will blink on and off if the amplifier’s

protection circuitry has been engaged (shutting the amp off to protect itself

and/or your loudspeakers). In the unlikely event that you see the power

indicator blinking, disconnect the amplifier from AC power and call your

dealer for assistance in solving the problem.

The standby indicator light (above the large standby button) glows either

amber or red, depending on the operational status of your amplifier. Amber

indicates that the amplifier is on and ready to be used. When the indicator

light is glowing red, the unit is in standby. If the standby indicator light is

completely off, the amplifier is not receiving power. Check your AC connec-

tions and the rear-panel AC fuse.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 29 30

Pas de commentaire

PROCEED AMP 5 Spécifications Page 13