PROCEED AMP 5 Spécifications télécharger pdf (Page 10)

Special Design Features

Congratulations on your purchase of a Proceed amplifier! While your new ampli-

fier is straightforward in its use, it includes several design features which are re-

sponsible for its outstanding performance. A few of these are given below.

Multiple power supplies Unlike other multichannel amplifiers, your new amplifier maintains outstanding

isolation and independence among its five channels. Three large toroidal trans-

formers are used, with complete left/center/right channel separation maintained

throughout. Separate secondary windings for front vs. rear channels on the Left

and Right transformers feed separate rectifiers and separate banks of filter caps.

In short, after the transformer, each channel has its own, dedicated power supply.

This approach reduces crosstalk between audio channels for superior imaging

and reproduction of acoustic space. Any demands placed on one channel have

virtually no effect on the performance of the other channel(s).

Low impedance power supply A critical factor in the ultimate performance of an amplifier is its “power supply

impedance,” which can be loosely thought of as the freedom with which the au-

dio circuitry has access to the power it needs, when it needs it. The design of

your Proceed amplifier has addressed this important characteristic in a compre-

hensive fashion. For example, the power supply capacitors (which act as “reser-

voirs” of power for the amplifier circuitry) are mounted directly to the printed

circuit board rather than using point to point wiring. The layout of the circuitry

uses short, thick traces for high current paths. Internal current capability is further

enhanced with high purity copper bus bars. This attention to detail yields an op-

timal environment in which the amplifier may operate to its maximum potential.

Balanced inputs Each channel of your amplifier is individually configurable to receive either bal-

anced or single-ended inputs. This approach allows you to take full advantage of

the greater immunity from noise, RFI, and EMI which balanced transmission of

audio signals offers on any preamp-to-amplifier connection where it is supported.

At the same time, any or all channels of the amplifier may be configured for

single-ended inputs to maintain compatibility with the majority of preamplifiers

available today. The gain structure of the amplifier adjusts automatically when you

select different inputs to facilitate this “mix and match” approach.

Robust output stage Each channel of your Proceed amplifier uses ten 150 watt power transistors.

These transistors are all individually tested and sorted, and are used in matched

sets to ensure that no one transistor bears a disproportionate part of the overall

load. The combination of an “overbuilt” design specification and extraordinary atten-

tion to detail in manufacturing improves performance, reliability, and longevity.

Extensive protection Your Proceed amplifier will shut itself down if it senses either the presence of

either DC (direct current) or a short circuit at the output, or any unsafe operating

temperature. In any case, a power relay will cause the amplifier to be discon-

nected from the AC mains. In addition, the AC input to each transformer is fused

to protect against any possibility of component-level failure that could draw dan-

gerous amounts of power. Finally, inrush limiting prevents premature aging of

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 29 30

Pas de commentaire

PROCEED AMP 5 Spécifications Page 10