PROCEED AMP3 Spécifications télécharger pdf (Page 13)

Rear Panel

Caution! Turn the volume on your preamplifier all the way down

before attempting to connect anything to your Proceed

BPA 2 or BPA 3.

1 AC MAINS RECEPTACLE

Connect the AC power cord (included in the accessory pack) to the I.E.C.-

standard AC receptacle on the rear panel of the BPA, then to the AC mains

outlet.

Warning! The Proceed BPA has been safety-tested and is designed

for operation with a three-conductor power cord. Do not

defeat the “third pin” or earth ground of the AC power cord.

2 REMOTE TURN-ON JACK

⁄8" “mini” jack above the AC mains receptacle on the rear panel allows

remote-controlled turn-on (that is, toggling between on and standby) of

the Proceed BPA. This remote “trigger” will be operated by 3–12 volts DC

level signal, with tip polarity as shown below:

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 21 22

Pas de commentaire

PROCEED AMP3 Spécifications Page 13